Ubiquiti Networks airVision Betriebsanweisung PDF herunterladen (Seite 9)

Outdoor Installation

5. There are three recessed areas for the Ethernet cable on the

Mounting Bracket Base. Thread the Ethernet cable through two

of the recessed areas and out the one that will be closest to your

power source.

Important: If the power source is above the camera, extend

the cable 70-80 mm below the camera body before routing

up to the power source.

6. Position the Mounting Bracket in the desired location and use a

pencil to mark the holes on the wall.

7. Use a 6 mm drill bit to drill the holes in the wall.

8. Insert a Screw Anchor into each hole.

9. Secure the Mounting Bracket to the wall using the Self-Tapping

Screws.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Keine Kommentare

Ubiquiti Networks airVision Betriebsanweisung Seite 9